Code 3 MC SuperVisor Charger - Manual (Page 4)

4
FIGURE 10 FIGURE 11-PASSENGER SIDE SHOWN FIGURE 12
FIGURE 13 FIGURE 14 FIGURE 15
FIGURE 7 FIGURE 8 FIGURE 9
FIGURE 16
Installation and Mounting Instructions: Cont.
Caution: Drilling into the housing of the light bar could damage wiring or other internal components.
WARNING: This unit must be mounted within the interior passenger compart-
ment of the vehicle only. It is not intended for use in exterior applications. All
devices should be mounted in accordance with the manufacturer’s instructions
and securely fastened to vehicle elements of sufficient strength to withstand the
forces applied to the device.
Driver and/or passenger air bags (SRS) will affect the way equipment should be
mounted. This device should be mounted by permanent installation and within
the zones specified by the vehicle manufacturer, if any. Any device mounted in
the deployment area of an air bag will damage or reduce the effectiveness of the
air bag and may damage or dislodge the device. Installer must be sure that this
device, its mounting hardware and electrical supply wiring does not interfere
with the air bag or the SRS wiring or sensors. Mounting the unit inside the ve-
hicle by a method other than permanent installation is not recommended as unit
may become dislodged during swerving, sudden braking or collision. Failure to
follow instructions can result in personal injury.