Code 3 HB4PAK - Manual

INSTALLATION &
OPERATION MANUAL
1
4 Pack LED H-A-B (Hide-A-Blast) Exterior
Introduction: Read all instructions and warnings before installing and using. The 4 Pak HAB Lights are for the
emergency vehicle market. The lights are to be connected through the Controller unit supplied in the kit, to a switch
connected directly to the +VDC power source in the vehicle.
Unpacking & Pre-Installation: Carefully remove the hardware, taking care not to scratch the lens, and inspect for
transit damage. Report any damage to the carrier and keep the shipping carton. Test the lights before installation. To
test, touch the black wire to the ground and the red wire to +VDC. If problems occur, contact the factory.
WARNING: This product contains high intensity LED devices. To prevent eye damage, DO NOT stare into the light
beam at close range.
WARNING: The use of this or any warning device does not ensure that all drivers can or will observe or react to an
emergency warning signal. Never take the right-of-way for granted. It is your responsibility to be sure you can pro-
ceed safely before entering an intersection, driving against traffic, responding at a high rate of speed, or walking on or
. g n ir i w d n a g n it n u o m t c e r r o c n o p u t n e d n e p e d y l h g i h s i e c i v e d g n i n r a w s i h t f o s s e n e v it c e ff e e h T . s e n a l c fi f a r t d n u o r a
Read and follow the manufacturer’s instructions before installing or using this device. The vehicle operator should
insure daily that all features of the device operate correctly. In use, the vehicle operator should insure the projection of
the warning signal is not blocked by vehicle components (i.e.: open trunks or compartment doors), people, vehicles, or
other obstructions. This equipment is intended for use by authorized personnel only. It is the user’s responsibility to
understand and obey all laws regarding emergency warning devices. The user should check all applicable city, state
and federal laws and regulations. Code 3, Inc., assumes no liability for any loss resulting from the use of this warning
device. Proper installation is vital to the performance of this warning device and the safe operation of the emergency ve-
hicle. It is important to recognize that the operator of the emergency vehicle is under psychological and physiological
stress caused by the emergency situation. The warning device should be installed in such a manner as to: A) Not reduce
the output performance of the system, B) Place the controls within convenient reach of the operator so that he can op-
erate the system without losing eye contact with the roadway. Emergency warning devices often require high electrical
voltages and/or currents. Properly protect and use caution around live electrical connections. Grounding or shorting
of electrical connections can cause high current arcing, which can cause personal injury and/or severe vehicle dam-
age, including fire. PROPER INSTALLATION COMBINED WITH OPERATOR TRAINING IN THE PROPER USE OF EMER-
GENCY WARNING DEVICES IS ESSENTIAL TO INSURE THE SAFETY OF EMERGENCY PERSONNEL AND THE PUBLIC.
INSTALLER: This manual must be delivered to the end user of this equipment.
LED CONTROLLER EXTENSION CABLE
MOUNTING
GROMMET x 2pcs LIGHTHEAD x 2pcs
12/24VDC
WARRANTY
Code 3®, Inc.’s emergency devices are tested and found to be operational at the time of manufacture. Provided
they are installed and operated in accordance with manufacturer’s recommendations, Code 3®, Inc. guarantees all parts
and components except the lamps to a period of 1 year, LED Light head modules to a period of 5 years (unless otherwise
expressed) from the date of purchase or delivery, whichever is later. Units demonstrated to be defective within the warranty
period will be repaired or replaced at the factory service center at no cost.
Use of lamp or other electrical load of a wattage higher than installed or recommended by the factory, or use of
inappropriate or inadequate wiring or circuit protection causes this warranty to become void. Failure or destruction of the
product resulting from abuse or unusual use and/or accidents is not covered by this warranty. Code 3®, Inc. shall in no way
be liable for other damages including consequential, indirect or special damages whether loss is due to negligence or breach
of warranty.
CODE 3®, INC. MAKES NO OTHER EXPRESS OR IMPLIED WARRANTY INCLUDING, WITHOUT LIMITATION,
WARRANTIES OF FITNESS OR MERCHANTABILITY, WITH RESPECT TO THIS PRODUCT.
PRODUCT RETURNS
If a product must be returned for repair or replacement*, please contact our factory to obtain a Return
Goods Authorization Number (RGA number) before you ship the product to Code 3®, Inc. Write the RGA
number clearly on the package near the mailing label. Be sure you use sufficient packing materials to
avoid damage to the product being returned while in transit.
*Code 3®, Inc. reserves the right to repair or replace at its discretion. Code 3®, Inc. assumes no responsibility or liability for expenses incurred for the removal and /or reinstallation of products requiring service
and/or repair.; nor for the packaging, handling, and shipping: nor for the handling of products returned to sender after the service has been rendered.
Problems or Questions? Call The Technical Assistance HOTLINE - (314) 996-2800
Code 3, Inc.
10986 N. Warson Road
St. Louis, Missouri 63114-2029—USA
Ph. (314) 426-2700 Fax (314) 426-1337
www.code3pse.com
Code 3,® Inc., a subsidiary of
Public Safety Equipment, Inc.
Code 3 is a registered trademark of
Code 3, Inc.
4
料號 ZCAR-F07-CO3
尺寸 A3(420x297mm)
編號： GD102XXXXXX
材質 , 120P
日期 20130731(版本1.0)
十字摺三摺