Code 3 H2Covert Siren User Manual

Page 10

Hand Held Controller (See Picture on Next Page)

The microphone for talk.

LEV1, when depressed/released once, supplies power to the load connected to Terminal A. This will also shut off the

siren if EU Lock Level 2 or 3, or Auto Siren is enabled. When depressed/released again, cuts power to Terminal A and

shuts off the siren if EU Lock Level 1 is enabled.

LEV2, when depressed/released once, supplies power to the load connected to Terminals A and B. This will also shut

off the siren if EU Lock Level 3 or Auto Siren is enabled. When pressed/released again, cuts power to Terminal B and

shuts off the siren if EU Lock Level 2 is enabled.

LEV3, when depressed/released once, supplies power to the load connected to Terminals A, B, and C. If Auto Siren is

enabled, then SIR1 siren will also turn on. When depressed/released again, cuts power to Terminals A, B, and C, and

shuts off the siren if EU Lock or Auto Siren is enabled.

AUX 1 – Auxiliary, when depressed/released once, supplies power to the load connected to Terminal D.

AUX 2 – Auxiliary, when depressed/released once, supplies power to the load connected to Terminal E.

AUX 3 – Auxiliary, when active, supplies power to the load connected to Terminal F. Active mode is determined by the

mode that AUX 3 is set to. This is set by Dip switch #3.

AUX 4 – Auxiliary, when active, supplies power to the load connected to Terminal G. Active mode is determined by the

mode that AUX 4 is set to. This is set by Dip switch #5.

RAD – When pressed, the radio rebroadcast function over-rides any active siren tone. When the RAD button is re-

leased, the siren will automatically switch back to the siren tone (if any) that was active when the button was pressed.

MAN – When depressed/released once, the siren will produce the Manual tone. This button over-rides any other siren

10.

tone being produced. If EU Lock is enabled, and the minimum Light Level is not currently on, then that Light Level will

also turn on.

AIR – When depressed/released once, the siren will produce the Air Horn tone. This button over-rides any other siren

11.

tone being produced. When the STBY button is depressed/held, the Air Horn button can be depressed/released to

select higher or lower pitch tones. Once the desired tone is chosen, release both buttons.

SIR – When depressed/released, the siren will produce the Wail tone. Continue to depress/release the button to scroll

12.

through the following tones (unless disabled): Wail, Yelp, Hi-Lo, Hyper-Yelp, Hyper-Lo, and Whoop. If EU Lock is en-

abled, and the minimum Light Level is not currently on, then that Light Level will also turn on.

SIR1 – Siren Tone 1, when depressed/released once, the siren will produce the tone preset at the factory (currently

13.

Wail). If EU Lock is enabled, and the minimum Light Level is not currently on, then that Light Level will also turn on. To

change the factory preset, depress and hold the STBY button, and then depress/release the SIR1 button to go to the

next available tone. Once the desired tone is chosen, release both buttons.

SIR2 – Siren Tone 2, when depressed/released once, the siren will produce the tone preset at the factory (currently

14.

Yelp). If EU Lock is enabled, and the minimum Light Level is not currently on, then that Light Level will also turn on. To

change the factory preset, depress and hold the STBY button, and then depress/release the SIR2 button to go to the

next available tone. Once the desired tone is chosen, release both buttons.

STBY – When depressed/released, any active siren tone is shut off. When depressed/held for 5 or more seconds with-

15.

out any other button press, the keypad dimming mode is entered (see the section titled “Keypad Backlighting Dimming

and Shut Off”). In addition this button is used to change the siren presets as described above.

PTT (Push To Talk) – The PA portion of the siren is activated each time the Microphone PTT button is pressed. When

16.

pressed, the PA function over-rides any active siren tone and routes the PA audio through the siren speaker. When the

PTT button is released, the siren will automatically switch back to the siren tone (if any) that was active when the button

was pressed.

Power/Volume Control - On/Off power is controlled by adjusting the wheel all the way upward, which turns the unit on

17.

and sets it to maximum volume. Scrolling downward from here decreases the volume. Scrolling further, past the physi-

cal detent, will turn the unit off.