Code 3 Astro L800, Star LL400, Nova L200 - Manual (Page 3)

3
Introduction
The Astro/Star/Nova "Flash" Series Strobe Beacons
represent the latest advances in state-of-the-art 360
degree strobe warning technology based on years of
research and testing. The latest MOSFET technology
and advanced design provide more efficient operation,
meaning superior performance, reliability and longer
life.
Unpacking & Pre-
installation
Remove the beacon from the box and examine the
unit for transit damage. A battery (+12/24 VDC) or
battery charger may be used to test the beacon. To
test, connect the black wire to the negative (earth)
terminal of the battery or battery charger. Touch the red wire to the positive (+12/24 VDC) terminal and verify
the unit's operation. Reversing the power connections will activate the reverse polarity protection, resulting in
no light output.
Installation & Mounting
The Flash Series Strobe Beacons are shipped fully tested and ready for installation. Refer to Figure 1 for
attachment points. Connect wiring as shown in Figure 2. Grommets and sealant should be used to keep
water out of your vehicle. The beacon will have a label covering the mounting holes "A" & "B" in the base.
The bottom label is intended to stop water entry into the beacon. Do not remove this label. Mounting screws
can be driven through this label for attachment to the vehicle.
Mounting Using Screws from
Underneath Beacon
Drill four clearance holes in mounting surface, using full size mounting hole template. (Hole A) Place the
base gasket between mounting surface and beacon. Drive 5/16-18 x 3/4 self-tapping screws up
through mounting surface into the base until tight.
Mounting Using Screws Driven Down
Through Base Into Mounting Surface
Remove lens and aluminum circuit case. Place the base gasket between mounting surface and beacon.
Drive user supplied self-drilling screws through holes into mounting surface. Alternatively, using full
size mounting hole template, drill four 11/64" holes (Hole B) and drive #8 tapping screws provided
through base and into mounting
surface. Use CAUTION not to
damage the printed circuit board
or strobe tube.
FIGURE 1
Hole B
Hole B
Hole B
Hole B
Hole A
Hole A
Hole A
Hole A
S96253