Code 3 920 Flashers - Manual (Page 3)

3
IMPORTANT NOTES:
•••••
The use of a flashing headlight system may be regulated by state,
county, or municipal authorities. It is the responsibility of the end user
to comply with these regulations.
•••••
Before attempting the installation of the 920 headlight flasher, thoroughly
read and understand instructions and steps shown below.
•••••
Disconnect the battery from the electrical system
before attempting any part of this installation.
•••••
Have your “Impala Police Package Owner’s Manual Supplement”
available for reference.
Installation:
1. Locate and remove the three, plastic fasteners that secure the cowl
panel covering the area between the top of the radiator support and
the top of the grille. Remove this panel from the vehicle.
NOTE: Each fastener must be returned to its original location when re-
installing this panel.
2. Locate and remove the two, passenger-side headlight pillar bolts
(see fig. 1).