Code 3 80 Series Perimeter Lights - Manual (Page 5)

5
For 80, 81 or 82 series models with optional bezel see instructions below otherwise continue
10. Test the lamp assembly (strobe or halogen) tube by connecting the reflector assembly to the cable and the
cable to the power source per the instructions with the power source.
11. Push the assembled AMP Mate-N-Lock connectors through the cut out in the vehicle.
12. Verify the "TOP" lens engraving is on the top. Mount the reflector and lens by installing the four screws.
For 80, 81, or 82 series models with optional bezel
10. Snap the reflector into the bezel making sure the reflector’s “TOP” aligns with the bezel’s "7002" product
number. When using the optional molded bezel gasket, make sure that the gasket is properly aligned with
the back of the bezel. Failure to properly align gasket could result in a poor seal between the bezel and the
mounting surface.
11. Test the lamp assembly by connecting the reflector assembly to the cable and the cable to the power
source per the instructions with the power supply.
12. Push the assembled AMP Mate-N-Lock connectors through the cut out in the vehicle.
13. Verify the orientation of the reflector. Mount the bezel and reflector by installing four of the screws sup-
plied. See Figure 5 for bezel/reflector screw location.
14. Verify “TOP” lens engraving is on the top of the lens. Attach the lens to the unit with the other four screws.
Note: screw should pull the lens tight when screwed into the vehicle.
Parts & Exploded Views
These 4 screws required for use
with trim bezel only.
2
8
1
7
FIGURE 5
4
3
4
6
5
9