BoonDocker POLARIS RZR XP 900 Turbo System - Manual (Page 8)

Revised 7/9/2013 Page 8 of 17
www.boondockers.com………………..... ……….………………....877-522-7805
31. Route the oil feed line from the turbo and to
the 4an adaptor installed on step 29. Make sure
to route hose away from any heat source and
abrasive objects. 32. INSTALLING FUEL LINE Locate and
cut the factory fuel line as shown in picture.
33. Insert a #4 hose clamp from either side of the
factory fuel line. Using the Boondocker fuel line
“T” into the stock fuel line as shown. 34. INSTALLING EXHAUST INLET
Apply hi-temp black silicone to the inside of the
turbo inlet.
35. With the 4-hole flange inserted between the
turbo and inlet, fasten the turbo inlet to the turbo
using the 4 8mm x 25mm bolts and lock nuts. 36. Fasten the turbo inlet to the stock header
using the 4 Boondocker hi-tension exhaust
springs. These springs are a tight fit, this is to
ensure this connection does not separate.