BoonDocker POLARIS RZR XP 900 Turbo System - Manual (Page 7)

Revised 7/9/2013 Page 7 of 17
www.boondockers.com………………..... ……….………………....877-522-7805
25. Route the 3/8” end of the oil drain line to the
oil drain on the motor. Use the 2 copper washers
to sandwich the banjo fitting and fasten to the
motor with the 12mm bolt. Zip tie as shown. 26. Use the provided rubber clamp and existing
bolt to fasten the oil drain hose to the motor.
Make sure the hose is not touching any abresive
objects or heat source
27. Using the remaining rubber clamp and self
tapping screw fasten the oil drain hose to the
shifter cable bracket as shown in picture. 28. INSTALLING OIL FEED LINE
Remove the 1/2”oil plug from the front of the
motor.
29. Apply a thread sealant to the 1/2” pipe
thread side of the 4an adaptor then install the
adaptor to the motor. 30. Locate the oil feed line and fasten to the oil
inlet on turbo as shown in picture.