CDI Torque MULTITEST Motorized Loader - Manual (Page 7)

iv
Using this Manual
This manual contains instructions for use and setup of the
Motorized Control Loader System . A table of contents and a
table of illustrations are provided to make this manual easy to
use.
Some of the information shown in text or illustrations is obtained
using optional equipment.
Conventions
This section contains a list of conventions used in text.
Check Note
A check note provides additional information about the subject
in the preceding paragraph.
Example:
System capabilities include, data storage, retrieval,
statistical analysis and automatic downloading to a
printer or computer.
Chapter References
Additional information in text is referenced by chapter number
and section name.
Example :
For testing procedures refer to Chapter 4—Using the
Multitest Torque Calibration System.
Equipment Damage
The possibility of damage to vehicle or equipment is introduced
by a signal word indicating this condition.
Example :
The connector on single transducer cables contains
the EEPROM calibration memory chip. Never
attempt to remove the connector from the
transducer. It is installed with a permanent
adhesive.