Catler BL 8011 - Manual (Page 6)

5
CATLER RECOMMENDS SAFETY FIRST
• Do not process hot or boiling liquids.
Allow to cool before placing into the
blender jug.
• Do not subject the blender jug to
extremes of hot or cold, for example,
placing a cold jug in hot water or vice
versa.
• Keep the appliance clean. Refer to care
and cleaning instructions in this manual.
• Once the blender motor has cooled
down - the icon will stop fl ashing and
you will be able to use the blender as per
instructions. At this point the blender will
be in standby mode and you will only
need to press the button that you require
to start blending again. However if you
have turned the blender off you will need
to switch it back on and only if the icon
has stop fl ashing commence blending as
usual.
iMPORTANT SAFEGUARDS FOR ALL
ELECTRICAL APPLIANCES
•
The appliance is for household use only.
• Fully unwind the cord before use.
• To protect against electric shock, do not
immerse the cord, plug or motor base in
water or any other liquid.
• Do not allow the cord to hang over the
edge of a table or bench, touch hot
surfaces or become knotted.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for
their safety.
• Children should be supervised to ensure
that they do not play with the appliance.
• It is recommended to regularly inspect
the appliance. Do not use the appliance if
the power supply cord, plug or appliance
becomes damaged in any way. Return
the entire appliance to the nearest
authorised service centre for examination
and/or repair.
• Any maintenance other than cleaning
should be performed at an authorised
service centre.
• Do not use this appliance for anything
other than its intended use. Do not use
in moving vehicles or boats. Do not use
outdoors.
WARNING:
PLEASE DO NOT ATTEMPT TO USE THE BLENDER WHILE THE “OVERLOAD
PROTECTION” IS FLASHING.
WARNING:
DO NOT OPERATE THE BLENDER CONTINUOUSLY WITH HEAVY LOAD FOR MORE
THAN 10 SECONDS.