Catler BL 8011 - Manual (Page 13)

12
CARE AND CLEANING
Disassembling the blender
Step 1
Always ensure the blender is off by pressing
the ‘Power’ button on the control panel.
Then switch off at the power outlet and
unplug the power cord.
Step 2
Remove the blender jug from the motor base
by grasping the handle and lifting the jug in
an upward direction.
Step 3
Remove the lid and wash as per care and
cleaning instructions.
Reassembling your blender after cleaning
Ensure all parts are clean and completely dry
thoroughly before placing blender jug onto
blender base.
Cleaning the motor base
Wipe the motor base with a soft, damp cloth
then dry thoroughly.
Wipe any excess food particles from the
power cord.
NOTE:
Do not use abrasive scouring pads
or cleaners when cleaning the motor
base as they may scratch the surface.
Cleaning the blender jug, lid, inner lid
Wash all parts in warm soapy water with a
soft cloth. Use a bottle brush to dislodge
stubborn foods around the blade assembly.
When cleaning the blender jug it is always
a good idea to clean straight away to avoid
food sticking to the blades and jug.
Placing about 200ml of warm soapy water
into the jug with the lid on and inner lid
in place you can blend this water for 5-10
seconds on a low speed which will help clean
the blades and jug. Then rinse jug in cold
water and dry thoroughly.
The blender jug may be placed in the bottom
shelf of the dishwasher on a standard cycle
only.
CARE AND CLEANING
WARNING:
DO NOT USE PETROL, SOLVENT, DISSOLVENT OR ANY SIMILAR AGENT FOR
CLEANING ANY PART OF YOUR BLENDER.
WARNING:
BLADES ARE SHARP PLEASE USE CARE WHEN CLEANING AROUND THE BLADES.
AVOID ANY CONTACT WITH BLADES. FOLLOW THE ABOVE MENTIONED
INSTRUCTIONS.