Catler ES 4011 User Manual

Page 19

1. Ensure the selector control is in the

“STANDBY” position, the POWER button
is in the ‘Off ’ position and the machine
is switched off at the power outlet and
unplugged.

2. Remove the fi lter holder and frothing

attachment. Pour the mixture of white
vinegar and water into the water tank.

3. Plug the machine into the power outlet

and switch on.

4. Press the POWER button to the ‘On’

position and turn the selector control
to the “STANDBY” position.

5. Place a large container under the group

head, and steam wand.

6. When the brewing temperature has been

reached the red heating light will switch
off . Turn the selector control to the

position to commence pour.

7. Once half the mixture of white vinegar

and water has run through the group
head turn the selector control to the
“STANDBY” position.

8. Set the selector control to the

position and allow the remaining
solution to run through the steam wand.
When the solution has run through, set
the selector control back to “STANDBY”
position.

9. After decalcifying, remove the water tank

and rinse thoroughly then re-fi ll with
fresh cold water. To rinse the machine,
repeat previous steps.

10. Espresso machine is now ready to use.

The stainless steel fi lters should not come
in contact with any decalcifying agents.
Do not use powdered decalcifying agents.

NOTE

CARE AND CLEANING

DO NOT USE ANY OTHER DECALCIFYING AGENTS, OTHER THAN VINEGAR.