beautypg.com

Catler ES 4011 User Manual

Page 12

background image

11

OPERATING YOUR ESPRESSO MACHINE ES 4011

 Set the selector to the position.

 After a few seconds*, the extraction of

espresso begins. A pumping noise will be
heard during this operation

* Pre-brew function
When you turn the selector button to

position, the boiler heating system pumps
water briefl y followed by a pause; then
continues to pump the water through to
the ground coff ee in the fi lter holder. This
pre-brew function is an advanced feature of
the Espresso Machine. The ground coff ee is
moistened by a small amount of water before
full extraction. The ground coff ee expands
and when greater pressure is built up, the
brewed coff ee is extracted with its full fl avor.
The pre-brew function is not possible to skip.
It is an inseparable part of the extraction
coff ee process.

 When suffi cient coff ee has been extracted,

set the selector control to the „STANDBY“
position. This will stop the fl ow of coff ee.

 If you do not need to use the steam

function, press the POWER button ‘Off ’,
unplug the power cord and allow the
machine to cool.

Recommended measurements are 30ml for
1 cup and 60ml for 2 cups.

NOTE

Emptying the fi lter holder
- Remove the fi lter holder from the group

head by rotating the fi lter holder to the left
until it releases.

- To empty the used coff ee grounds, turn

the fi lter holder upside down in a bin and
gently tap out the coff ee puck (used coff ee
grounds should be thrown away with
domestic waste and not down the sink
which may block drains).

- Remove the fi lter by pressing on the

„EJECT“ button on the underside of the
fi lter holder.

- Rinse the fi lter and fi lter holder with water

and allow drying.

The machine remains ready for brewing and
maintains a constant heating temperature
as long as the POWER switch is left ‘On’.
If the temperature should drop, the red
heating light will illuminate and the
machine will automatically heat up to the
correct brewing temperature.

NOTE

THE METAL PARTS OF THE FILTER HOLDER MAY STILL BE VERY HOT. COOL
THESE PARTS IN COLD WATER.