CASO Germany AirVital Pro - Manual (Page 32)

caso AirVital Pro 32
13 Operation and Handing
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
13.1 Filling the water tank
Take the nozzle (1) and handle cap (2) (linked from).
Remove the tank (4) from the chassis.
Remove lid (8) and fill the water tank of tap water or filtered water is.
They seal the tank by screw the lid carefully.
Place the water on the housing.
Put on the nozzle (1) and handle cap (2) and plug the power cord.
Note
► Do not add water directly to water sink, always add water into water tank.
► Before using the humidifier for the first time, all parts should be cleaned with tap water.
► Fill in any water that is hotter than 40 ° C, no flavor additives or chemical additives.
► Make sure that the tank is sealed and no water escapes.
► The outlets for water vapor can be rotated 360 ° in different directions.
► If the water is used up, the display flashes "on water" and the unit switches off
automatically.
► Turn off the device using the switch on / off, disconnect the plug from the outlet and fill
for water.
Please let the unit cool down 60 min. Before you take of the water tank and refill with
water. Attention: The device is hot!
13.2 Remote control usage
1. Battery
2. Battery holder
13.2.1 Battery installing:
Please pull out the battery holder at the end of the remote control. Then put
the coin cell with marking upwards into the holder and push back the holder
into the remote control.
13.2.2 Battery replace:
Please pull out the battery holder at the end of the remote control. Then take out the old
battery and put a new coin cell with marking upwards into the holder. Push back the holder
into the remote control.
13.2.3 Type of Battery:
Li-Mn02 coin cell CR2025