CASO Germany AirVital Pro - Manual (Page 31)

caso AirVital Pro 31
• The electrical outlet must be protected by a 16A safety cut-out switch.
• The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
• Make sure that the power cable is undamaged and has not been installed under the ice
maker or over hot or sharp surfaces.
• The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.
12 Design and Function
This chapter provides you with important safety notices on the design and function of the
device.
The AirVital PRO generates ultra fine mist due to the new hybrid evaporation technology
12.1 Complete overview
1. Nozzle 2.Handle cap
3. Handle 4. Water tank
5. Water level sensor 6. Air flue
7. Mist tube
8. Water tank cover (and 8a waterfilter)
9. Transducer 10. Heating element
11. Power cord 12. Aroma box
13. LED-Display 14. On/off button
15. Mist level button 16. Timer button
17. Set humidity button 18. hot mist button
19.Auto button
12.2 Safety equipment
If the tank is empty, the unit stops automatically.
Please note
► Turn off the device using the switch on / off, disconnect the plug from the outlet, wait
about 60 min. To let the unit cool down and than fill with fresh water.
12.3 Rating plate
The rating plate with the connection and performance data can be founded beneath the
device.