CASO Germany VC 220 Vacuum Set - Manual (Page 47)

caso Vakuumierer VC220
47
The first weld on the
cut off piece of the roll
is not being carried
out.
Roll is not positioned
correctly
Follow the steps in the chapter
“Vacuum packaging in a bag
originating on the roll”
A complete vacuum is
not being created in
the bag.
The open end of the bag is
not completely inside the
vacuum chamber
Position the bag correctly
The bag is defective Select another bag
There is dirt on the welding
and the normal seals Clean the seals and retry
correctly once they are dry
The bag is not being
welded correctly The welding bar is
overheating so that the bag
melts
Open the cover on the unit and
let it cool down for a few minutes
The bag does not hold
the vacuum after it has
been welded shut
The bag is defective
Select another bag; wrap paper
serviettes around any sharp
edges on the content
There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids.
Open the bag again and clean
the upper internal part of the bag
and remove any foreign matter
that might be on the welding bar
before you weld the bag shut
again.
Please note
►
If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
17 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety.
If these were put in the non-recyclable waste or were handled incorrectly, they could be
detrimental to human health and the environment. Therefore, do not put your old device
into the non-recyclable waste under any circumstances.
Please note
► Utilise the collection point, established in your town, to return and recycle old
electric and electronic devices. If necessary, contact your town hall, local refuse
collection service or your dealer for information.
► Ensure that your old device is stored safely away from children until it is taken
away.