CASO Germany M 20 electronic - Manual (Page 41)

caso M20 electronic (pure white) 41
9.7 Unpacking
To unpack the device, proceed as follows:
• Remove the device out of the carton and remove the packaging material.
• Remove the accessories located in the cooking chamber and remove the packaging
material.
• Remove the red coloured safety adhesive strip on the floor of the cooking chamber.
• Remove the blue protective film on the device itself.
Please note
► Only remove the blue protective film shortly before setting up the device in the location
where it will be used, to prevent scratches and dirt accumulations.
► Please don’t remove the protective film from the inside of the door (if equipped), since
this makes the cleaning of the device easier.
9.8 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled. Returning the packaging back to the
material loop saves raw materials and reduces the quantities of accumulated waste. Take
any packaging materials that are no longer required to “Green Dot” recycling collection
points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.
9.9 Setup
9.9.1 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
• The device must be set up on a firm, flat, horizontal and heat-resistant surface with
sufficient load-bearing capacity for the oven and the maximum weight of the expected
food that is to be prepared in the oven.
• Choose the setup location in such a way that children cannot reach any hot surfaces on
the device.
• The device is not intended to be installed in a wall or a built-in cupboard.
• Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
• The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 20 cm above the oven, 10 cm around the back and 5 cm on both sides.