Salter Brecknell RGT160 - Manual (Page 6)

(4) Read the height of the person as follows:
If the back of the spoon points to the outer height rod,
then it points to the correct height.
--If the back of the spoon points to the inner height
rod, then the correct height is read at the top of the
outer height rod (see
“Read” arrow on the outer
height rod).
(5) While holding the spoon
horizontally, raise the
spoon above the person’s
head. The person may
now step off of the scale
platform. Hold the spoon
horizontal until the person
is clear of the height rod.
(6) Rotate the spoon back to
the vertical position and
adjust the height rod back
to the rest position (i.e. the
spoon should be locked in place within the inner
height rod and the inner rod should be at its
lowest position).
5
Assembly Instructions:
1.
This precision instrument is extremely easy to set up;
all major parts are factory pre-assembled. Before starting to
assemble, please unpack carefully and remove all
wrappings and fillers.
Carton contains:
(1) Column with head.
(2) Platform Base.
(3) Height measuring rod.
2. NOTE! If column bracket is bent, straighten before
assembling. Slip column over column bracket on platform
base. Hold column straight so that draft rod enters opening
in column bracket. Screw column to column brackets (two
M6 truss head screws in front of column, four in back).
3. Lay down scale, with column horizontal to floor.
(1) Raise draft rod keeping out of lever’s way.
(2) Push lever.
When lever is in position, hook draft rod around pivot.
2