Salter Brecknell RGT160 - Manual (Page 4)

4. Optional Height Rod installation:
(1) Remove the cardboard insert from the height rod.
(2) Insert the two hex head screws from the hardware
pack into the holes in the front of the column and
tighten them with the wrench.
(3) Place both height rod brackets over the two pre-
installed hex head screws and pull down.
(4) Use the included wrench to tighten both hex head
screws. Do not over tighten the screws.
3
Operation
Weighing Operation
To balance scale, move both posies (weights) to zero
and turn balance screw to right or left until scale
balances. For accurate weighing, place scale on level
floor.
To determine the weight move the coarse and fine
weights to the proper position for the scale to balance
on the zero indicator and reed the weight by adding
the amount shown on each beam.
Height Rod Operating Guide:
(1) Before the person steps onto the scale platform, the
spoon should be rotated to the horizontal position, and
raised well above the person’s apparent height.
(2) The person may now step onto the scale platform.
The spoon should be held horizontal and above the
person’s head.
(3) Carefully lower the spoon, while keeping it horizontal,
until it rests gently upon the top of the person’s head.
If the person is shorter than 101.5cm(3’4”), push the
latch to the right, while simultaneously pushing down
on the spoon until the spoon rests horizontally upon
the top of the person’s head.
4