Salter Brecknell B225 - Manual (Page 40)

7 Error Messages
40 B225 User instructions
7 Error Messages
Error codes:
E0 Scale requires reset. (Disconnect then reconnect power
supply.)
E5 Scale requires reset (Disconnect then reconnect power
supply.).
E10 Battery failure. Replace battery (do not use NiCad
batteries).
E11 Supply voltage is too high.
E20 Weight error. Remove all items from the weighpan, then
press and hold the clear key.
E30 Management mode not exited correctly. Re-enter
management mode, select the value to be changed,
change the value and go to the next branch to accept
the change.
E40 Weight error. Remove all items from the weighpan, then
press and hold the clear key.
E42 Weight error. Remove all items from the weighpan, then
press and hold the clear key.
E100 Invalid PLU contents. Re-program the PLU.
E102 PLU write failed. PLU is protected.
E103 Tare error. Remove all items from the weighpan, then
press and hold the clear key.
If a persistent error message appears or the
scale locks up, disconnect then reconnect
the scale to the power supply. If the scale
remains inoperative, contact your authorized
service agent.
E 102
nnnnnnnn
$$$$$$$$ uuuuuuuu -------- ########
Temporary
error
Weight
unsteady
Balance
failed
Over range Under range