Salter Brecknell B225 - Manual (Page 38)

6 Management mode
38 B225 User instructions
PC protocol
A PC can be connected to the serial port of the scale. The PC
can then act as a remote terminal to control the scale, and
display scale / weight information.
To set up the scale for PC protocol you must first configure
the following:
• Serial port configuration- Branch 36 on page 33
• Printer configuration - Branch 38 on page 34
PC protocol commands and codes
The scale’s RS-232 bidirectional communication works in a
server/client protocol. A computer server sends a command
code to the scale (client) which will return a response to the
server device or perform a scale function. Commands to the
scale are in uppercase, terminated with a carriage return.
Scale responses begin with the lowercase equivalent of the
command code.
COMMAND RESPONSE DESCRIPTION
CA none Clear Sample
CC cc_xxxxx Request piece count
CP cp_xxxxxx_uu Request piece weight value
CM none Switch to count mode
DIxxxxxxxx none Display message xxxx
(message is 8 characters max)
IC none Reset Scale (warm start)
PWx.xxxxx_uu none Loads xxsx.x as piece weight
TR tr_x.xxx_uu Request tare value
TZ none Clear the current tare
Txxxx.x_uu none Loads xxxx.x as tare
WD ws_x.xxxx Request net weight
WE we_x.xxx_uu Request net weight with units