AVer IWH3216 Touch3216 Touch II quick guide - Manual (Page 4)

2
II. Hardware Installation
Install the Hard Disk
IWH3216 Touch
The DVR unit can support up to 3 SATA hard disks. The hard disk installation steps are same for
IWH3216 Touch. Follow the illustrated instructions below to install the hard disk:
1. Loosen all screws (2 sides and back) and
Push the cover backward and lift to open the
case cover. 2. Loosen the screws of holder to make hard
disk install more easily.
3. Loosen all the screws of hard disk plate. 4. The hard disk plate can be installed 3 hard
disks. User can choose the position and
place the hard disk on it.
5. Turn the plate and hard disk over carefully
and secure the hard disk on the plate. If
hard disk cannot be fit to the screw hole,
then, you may adjust the hard disk position
to fit the screw hole. 6. Screw the plate within hard disk inside the
DVR unit.