AVer CM5000 - Manual (Page 133)

126
5. DwellTime: for how long the camera stays in that position before it moves to the next one
(the setup time period is 1~60 seconds). After is done, click Save to keep the settings.
6. Restore AutoPan Time: set a time period for restoring auto path function after the PTZ
camera has been moved. Mark the check box and set the time period in second.
7. Click Apply to save the settings.
8. After completing the PTZ setting, user can operate the PTZ function through PTZ control
panel in preview mode (see also Chapter 4.1.2 ).
Setup Analog PTZ
User can enable PTZ function if the analog camera has supported.
1. In setup mode, select the NVR/DVR server. Then, click  of Camera setting to expand
the camera list.
2. Then, select Camera # > PTZ tab. In PTZ setup page, click Use PTZ to enable PTZ
3. In PTZ page, mark Use PTZ to enable PTZ function.
4. Connection Settings: select the following selections and click Save to apply the settings.
 COMPort: The connecting port is fixed and can ’t be changed. The default is RS485
port.
 ID: Assign an ID number for the PTZ camera.
 Baud Rate: Please refer to the user
’s manual of the PTZ camera to make sure the
baud rate.
 Protocol: Please refer to the user ’s manual of the PTZ camera to make sure what
protocol is using.
Use the direction
buttons to adjust the
lens of camera to
desired position.
Use these 2 buttons
to Zoom in/Zoom out
the lens.
Use these 2 buttons
to Focus in/ Focus out
the lens.
Direction buttons’ moving speed