Crimestopper Security Products CS-2011RS SERIES IV User Manual
Super rage™ the informer, Installation instructions, Introduction
This manual is related to the following products:
Table of contents
Document Outline
- CS-2011RS Series IV & CS-2015FM / TW1 Series II
- INSTALLATION INSTRUCTIONS
- SIREN MOUNTING: Mount the siren under the hood to fender-well or other body surface with the open end facing downward. Run the red siren wire through the firewall using a rubber grommet. Ground the black wire to the body metal near the siren.
- Green: MODE A: (-) Start Activation Input
- Green: MODE B (-) Optional Turbo Timer Input
- Brown/White: (-) Horn Honk Output (Optional, may require a relay)
- Black/White: (-) 500mA Dome Light Illumination Output (Optional, Requires relay)
- Green/Red: Remote Aux. Output 1 OR MAP-Mobile Accessories Protection (Optional, requires relay)
- Blue/White: (-) Passenger Door Unlock Output (Optional, requires relay)
- STARTER DISABLE:
- Sensor Adjustment
- GREEN: (-) LOCK / (+) UNLOCK
- BLUE: (-) UNLOCK / (+) LOCK[READ BELOW FOR COMMON DOOR LOCK TYPES]
- RED: +12V Coil Power for external relays
- HINT! This system provides BOTH Positive and Neg
- Negative or Positive Trigger (-/+): Many Vehicles: Imports, Ford, GM, Chrysler and European
- 6. PARKING LIGHTS ON WITH DISARM:
- 7. GREEN/RED WIRE PROGRAMMING: TRUNK POP (AUX 1) or M.A.P. OUTPUT:
- 8. PINK WIRE PROGRAMMING: CAR JACK TRIGGER or GLOW PLUG INPUT:
- 9. SIREN CHIRPS WITH REMOTE START ACTIVATION:
- ENGINE CRANKS VEHICLE BUT VEHICLE NEVER STARTS:
- VEHICLE STARTS BUT CHECK ENGINE LIGHT COMES ON OR ENGINE RUNS BADLY: