Alumax K-NS91Z - Manual (Page 10)

4
10
WALL JAMB INSTALLATION
INSTALLATION MANUAL
Place the door panel assembly at the bottom of the
tub using a piece of cardboard under the door for
protection.
Insert the wall jambs into the expander and place
the frame in its final position
Level the shower frame. Mark the drilling location of
the holes for the wall jamb then remove the frame
temporarily.
With a 1/4” drill bit*, drill 4 holes into the wall using
the marks done in the previous step. Place a drop
of silicone in each hole and insert 4 wall plugs. This
step must be done on both sides.
Screw only one wall jamb onto the wall, It must
be the one where the magnetic expander will be
inserted.
Insert the second wall jamb into the expander on the
side of the fix panel.
Insert the frame at an angle by placing the magnetic
expander into the wall jamb which is fixed on the
wall. Slide and center the frame in the opening by
streching the second wall jamb to the wall.
Screw the second wall jamb onto the wall by using
1 1/4” screws (3). The wall plugs should already be
installed in whe wall. Install the screw caps (3).
4a.
4b.
4c.
4d.
4e.
4f.
4g.
4h.
4a
4b
4d
INTERIOR
SHOWER SIDE
*To install the shower door on ceramic tiles, use a 1/4’’ drill bit for ceramic tiles.
*