Alumax K-NS93Z - Manual (Page 16)

4
16
WALL JAMB INSTALLATION
INSTALLATION MANUAL
Place the wall jambs against the wall so that
the holes are located towards the interior of the
shower. Center the opening of the wall jamb on
the line marked previously. Ensure verticality
with a level. Mark the holes position with pencil
using the holes of the wall jamb for reference.
Drill the holes in the wall with Ø1/4’’ drill bit.
To install the shower door on ceramic tiles, use
a Ø1/4’’ drill bit for ceramic tiles.
Insert one drop of silicone in each hole bored
in the wall before inserting the wall plug (x8) on
both side.
Screw the two wall jambs into the wall plugs
already installed in the wall by using screws
1 3/8’’ (x8). Ensure verticality with the level.
Put screw caps on the screw heads.
Insert the wall jambs into the expander and
place temporairaly the frame centred on the
threshold line marked previously.
4a.
4b.
4c.
4d.
4e.
19
4a
4b
4c
K-NS93Z