Alumax K-NS93Z - Manual (Page 14)

4
14
WALL JAMB INSTALLATION
INSTALLATION MANUAL
Place the door inside the shower by protecting the surface of
the base. Insert the wall jambs into the expander and place
the frame in its position temporaraily
Level the shower frame. Mark the drilling location of the holes
for the wall jamb then remove the frame temporarily.
With a 1/4” drill bit, drill 8 holes into the wall on the side of
the opening of the door using the marks done in the previous
step. Place a drop of silicone in each hole and insert 8 wall
plugs.
Fasten the wall jamb on the side of the opening of the door by
using 1 3/8” (4) screws and the wall plugs already installed .
Place the screw caps(4).
Insert the second wall jamb.Reposion the frame onto the
center of the threshold.
Screw the wall jamb into the wall plugs already installed by
using screws 1 3/8” (4) and place the screw caps .
4a.
4b.
4c.
4d.
4e
4f
3D
4a
4b
4c
INTERIOR
SHOWER SIDE
4b
17
K-NS91Z