Alumax L-523 - Manual (Page 12)

INSTRUCTION MANUAL
BOT
503X, 513X, 523X, 523TBX
TOM CLIPS INSTALLATION
13.25”
335mm
13.25”
335mm
center of threshold
center of exposed base
1a. Using the measuring tape, mark the center
of the threshold of the base. Find the center
of the exposed base and draw a line to the
center of the threshold. The line must be
perpendicular . Place both bottom clips (5)
along the line of the center of threshold.
Mark the screw location following the
dimensions shown in the drawing.
Dimensions on the drawing are for
ABN3672 base installation.
1b.
1c. Apply
Remove the bottom clips to drill the base
using #1/8” drill bit.
silicone into the groove at the bottom
of the clip and around the hole dirlled.
Fasten the bottom clips to the base using
the provided screws. Place the gaskets into
bottom clips slots.
1
1a
1b
5
1c
9
5
CLEAR GASKET
5