Alumax L-422 - Manual (Page 15)

2
2d.
2e.
2f.
Remove the front panel (4) by
disassembling the corner clip back plate.
Drill pilot hole on the base with Ø1/8” drill
bit according to marking.
Apply silicone sealant into the groove on
the underside of the piece and around pilot
holes.
Fasten the bottom clips (8) to the base with
# 6 –1” provided screws and replace the
gasket.
Reinstall the front panel (4) by sliding into
the bottom clips (8).
Level all panels prior to tightening the
corner clips back plates and bottom clips
set screws.
Remove the bottom clips from the front
fixed panel (4).
2d
CONTINUED
2f
12
2e
4
8
INSTALLATION MANUAL
301X, 302X, 421X, 422X, 421TBX, 422TBX