Alumax L-210 - Manual (Page 15)

INSTALLATION MANUAL
1
15
INSTALLATION MANUAL
CONTINUED
1e. Place the bottom clips (3) for return panel on the
line traced previously following dimension shown
on the plan view. Mark the screw location.
Remove temporary the bottom clips to drill the base
using Ø1/8” drill bit.
Put silicone onto the bottom clip bottom face groove
and around the hole. Finally, fasten the bottom clips
to the base using the provided screws.
Place the gaskets into bottom clips slots.
1f. Slide the return panel assembly (1.1) into the wall
jamb (2) and through the bottom clips slots.
Once the return panel (1.1) has been adjusted,
secure the expander (1.2) to the wall jamb (2) by
way of a clamp so as to keep the return panel
level.
1h. By way of #8- 3/8 screws (7.2), as well as screw
caps (7.4) secure the wall jamb (2) to the
expander (1.2).
1g. Tighten the bottom clips set screws (3).
1f
1g
1e.
8
3.3
3.1
3 3
1.2
1.1
7.4
2
7.2
2
3
30” (76cm) [56312-56313]
37” (15cm) [56310-6310-6311]
4 1/4” (11cm)
INTERIOR
SHOWER SIDE INTERIOR
SHOWER SIDE
3
1h
100X, 210X, 210TBX