Alumax DesignLine Hinge - Manual (Page 5)

Page 5 of 5 EPH-N00-06092
12-9-03
6
Set panel back on spacers and screw one screw into
the hole you drilled on the top hinge. Set your panel plumb
with a level. Mark the rest of the holes, remove panel and
drill all the holes.
Add a small amount of silicone to each hole.
You may want to cover the hinge leafs (A and B) and back
plate (C) with masking tape to prevent scratching with the
screwdriver, drill or drill bit.
Set panel back on spacers and screw in all the screws with
a screwdriver. (It is not recommended that you use a
power drill. If you do, you MUST use a screw bit that is
at least 4"-5" long so you don't scratch the surface of the
hinge. There is not enough room for a standard screw bit.)