Alumax 694 - Manual (Page 5)

Page 5 of 6 EPH-N00-06064
3-8-04
5
Cut the drip vinyl [E] 1/2" longer than the drip
deflector [D] and notch it on each end as shown. Slide the
drip vinyl into the deflector and glue or crimp the ends of
the vinyl slot.
Clean the inside edge of the bottom door rail and the flat
side of the deflector thoroughly to ensure proper adhesion
of the double stick tape [K]. Unroll the tape and carefully
attach it to the back of the deflector (do not peel the tape
backing yet).
4
Secure the side panels to the wall jambs with six (6)
#6 x 3/8" pan head tek screws. These screws do not require
drilling through the wall jambs, however, predrilled pilot
holes in the panel rails are provided for guiding the screws.
6
Hold the drip deflector [D] against the inside of the
door bottom rail, positioning it properly so that the door
closes without interference. Mark the location of the drip
deflector on the top edge and side. Peel the backing off of
the double stick tape [K] and carefully (you only get one
try) stick the drip deflector to the door using the marks for
alignment.