Alumax 650S - Manual (Page 5)

Page 5 of 8 EPH-N00-06015
1-29-09
6
4
Replace one wall jamb [B] and attach to wall with
two #8 x 1 1/2" truss head screws [D] inserted through
the top and bottom holes. Slip a nylon spacer [E] over
a #8 x 1 1/2" truss head screw and install in the center
hole of the wall jamb. Check jamb for plumb and tighten
screws.
NOTE: Do not overtighten the jamb screws.
NOTE: Obscure glass doors should be installed
with the rough surface of the glass to the exterior of the
unit. Deco or etched glass doors should be installed
with the patterned surface to the inside.
On doors with obscure or etched glass, there is an interior
and exterior glazed door panel
[G] as determined by the
position of the top bearing fin. Door panels with clear
glass are interchangeable.
Attach the four nylon roller bearings
[H] to the door
panels as shown, using #8-32 x 3/8" hex head screws
[J] centered in the outside slots in the top bearing fins.
5
This bath enclosure is equipped with safety tee-
lock wall jambs. When properly installed, the header
is permanently locked to the wall jambs and cannot be
accidentally dislodged.
Measure the wall-to-wall opening at the top of the wall
jambs
[B] and cut the header [F] 1/16" short of this
dimension. Check the header for fit.
Slide the safety tee-lock of the unmounted wall jamb
[B]
into the end of the header. The header is reversible so
that either face may be turned to the exterior of the unit.
Holding the header at an angle, engage the other end
onto the mounted wall jamb. Pivot the header into place,
then slide the loose wall jamb to the wall and press into
position on the tub track. Attach the jamb to the wall per
instructions in Step #4.