Alumax 650S - Manual (Page 2)

EPH-N00-06015
1-29-09
Page 2 of 8
LIMITED WARRANTY AND REMEDY
A
LUMAX
B
ATH
E
NCLOSURES
warrants to its dealers, customers, and all subsequent purchasers and users,
that the products supplied by it shall be free from material defects in material and workmanship for a
period of one (1) year after shipment, provided they are installed and maintained according to A
LUMAX
B
ATH
E
NCLOSURE
's recommended practices and installation instructions. This warranty shall apply only
to defects appearing within one (1) year from the date of shipment, and provided that A
LUMAX
B
ATH
E
NCLOSURES
is promptly notified in writing of such defects. The sole and exclusive remedy with respect
to the above warranty or with respect to any other claim relating to defects or any other condition or
use of the products supplied by A
LUMAX
B
ATH
E
NCLOSURES
, however caused, and whether such claim
is based upon warranty contract, negligence, strict liability, or any other theory, is limited to repair or
supply of such products, or repayment by A
LUMAX
B
ATH
E
NCLOSURES
of the purchase price paid for it, at
A
LUMAX
B
ATH
E
NCLOSURE
's option.
A
LUMAX
B
ATH
E
NCLOSURES
does not make any other representations or warranties, express or implied,
including, but not limited to, any implied warranty of merchantability and any implied warranty of fitness
for a particular purpose. In no event shall A
LUMAX
B
ATH
E
NCLOSURES
be liable for special, direct, indirect,
or consequential damages, including, but not limited to, loss or use of profits.
Dealers agree to pass on to its customers and users in writing A
LUMAX
B
ATH
E
NCLOSURE
's Warranty and
Remedy as set forth above.
Laws and building and safety codes governing the design and use of bath enclosures vary widely.
A
LUMAX
B
ATH
E
NCLOSURES
does not control the selection of product configurations, operating hardware
or glazing materials, and assumes no responsibility therefor.
INSTALLATION NOTES
Unpack your unit carefully and inspect for freight damage. Lay out and identify all parts using the in-
struction sheets as a reference. Before discarding the carton, check for small hardware bags that tend
to fall to the bottom of the box. If any parts are damaged or missing, refer to the descriptions noted in
the instructions when contacting your dealer for replacements.
Handle glazed panels carefully and protect the edges. Safety tempered glass is very resistant to break-
age, but the sharp corners of the panels can damage tile and floor coverings.
Please wear safety glasses whenever drilling or cutting. When drilling holes in ceramic tile or marble, use
a center punch and hammer to carefully break the surface glaze so the drill can start without skidding.
To install your A
LUMAX
Bath Enclosure you will need the following: tape measure, level, #2 Phillips
screwdriver, flat screwdriver, drill, 1/8", 7/64" and 3/16" drill bits, hacksaw, pencil, and caulking (clear
silicone recommended). Optional tools include a miter box for cutting parts to length, files, center
punch, and masking tape.
NOTE: Before beginning installation, check the tub rim for level and both walls for plumb. If either are
off more than 1/4" to 3/8", you may want to contact your dealer for tapered fillers which can be used
to level the tub track or plumb the wall jambs.