Alumax 300cv - Manual (Page 8)

Page 7 of 7 EPH-N00-06095
5-19-04
10
11
Locate the handle [K] that has no Set Screws.
Place a Plastic Bushing [M] in the top handle hole then place
a Plastic Washer [L] against the glass. Place the handle
without Set Screws against the Plastic Washer and insert the
threaded end of the Cone Head Screw [N] through the
bushing into the threaded insert in the end of the handle and
tighten. Repeat the procedure for the bottom hole. Place
Plastic Washers [L] against the opposite side of the glass
and press the remaining handle [K] over the end of the Cone
Head Screw. While holding the handles firmly against the
glass tighten the Set Screws [O].
Neatly caulk the inside perimeter of the shower
curb and the wall jambs.
NOTE: Improper caulking will result in leaks.
NOTE: The caulking should be allowed to cure for twenty-
four hours before using your new shower enclosure.
The Care and Cleaning of your new Alumax Bath Enclosure. The simplest and preferred
method of cleaning your unit is by washing it with clean water and drying with a soft cloth. If soil
is still present after drying, a non-abrasive cleanser with a pH of seven to eight may be used. Comet
Bathroom Cleaner
® has been tested and is recommended by the Bath Enclosure Manufacturers
Association (BEMA). Do not use scouring pads, sharp instruments, or acid-based cleansers to
clean the unit.
Thank you for choosing an Alumax Bath Enclosure. Please take a moment to complete and
return the enclosed Customer Response Card. The information you provide helps us improve
the quality of our products and provide better service to you, our customer.