Alumax 300cv - Manual (Page 7)

EPH-N00-06095
5-19-04
Page 6 of 7
7
9
8
Inside the shower enclosure, drill two 1/8" holes
thru the hinge jamb and into the wall jamb [C] 3/8" to
3/4" from the wall and approximately 1" vertically
from each end of the hinge jamb. Drill a third hole
centered between the first two, then enlarge the three
outer holes with a 3/16" drill for clearance on the self-
tapping screws. Attach the door panel assembly
permanently with three #6 x 3/8" pan head screws
[F].
Slide the latch [J] with magnet onto the strike edge
of the door panel. Close the door and slide the latch up
or down until the two magnetic strips are aligned. Use a
pencil or masking tape to mark the location of the latch
on the door.
Wrap the latch vinyl [H] over the edge of the door glass
between the marks and carefully drive the door latch
onto the door panel. Spraying glass cleaner or water
onto the vinyl will make assembly easier.
Close the door and check for proper operation of the
magnetic catch.
1/8"
Determine the desired handing of the deflector [P].
The deflector leg must go to the inside of the unit and the
notch fits under the hinge rail as shown in the drawing at
right. To determine the door panel width measure the
distance from the edge of the hinge rail to the far edge of
the glass door panel. The deflector should be cut to Door
Panel Width - 7/16". Press the deflector firmly on the
bottom edge of the glass as shown.