Clarity Amplified Telephone C35 - Manual (Page 12)

12
GETTING STARTED
4. Plug the fl at telephone line cord into the wall plate
jack, then align the mounting bracket’s keyhole slots
with the wall plate studs and slide the base of the
phone downward to secure it on the wall.
See Figure 6.
5. Plug one end of the coiled handset cord into the
bottom of the handset. Plug the other end of the
handset into the modular jack marked HANDSET
located on the left side of the phone. Place receiver in
the cradle. See Figure 7.
6. Set the TONE/PULSE switch located on the back
of the base to correct dialing mode. Please check with
your local telephone company if uncertain of the type
of service.
7. Locate the small hook on the handset cradle on the
base. Pull the hook out and turn around so the small
lip faces upward to support the handset.
8. Lift the handset and listen for a dial tone. The phone is
ready to use.
M1 M2
M5 M6 M7 M8 M9 M10 M11
M3 M4
Figure 7
M1 M2
M5 M6 M7 M8 M9 M10 M11
M3 M4
1
Figure 8
1. Plug one end of the long
fl at telephone line cord
into the jack marked
LINE located on the
back of the telephone.
MANUAL
AUTO
Figure 6