LG L1810ER - Manual (Page 17)

Operating Instructions
Operating Instructions
Remote Control Operations
The controls look like this:
Controls
oo
UU ^
TEMP
MO
------
DE
<
TIIUlER
1
FAN
SPEED
V
1
V il V
1) POWER
Operation starts when this button Is pressed and stops when you press the button again.
^ FAN SPEED SELECTOR
For increased power while cooling, select a higher fan speed. 3 steps: High —Low—Med
^ ON/OFF TIMER
The timer can be set to start and stop the unit in hourly increments (up to 12 hours).
You will usually use shut-off time while you sleep.
For your sleeping comfort, once timer is set, the temperature setting
will raige 2°F after 30min and once again after another 30min.
4) OPERATION MODE SELECTOR
Select cooling mode to cool the room.
Select energy saver mode for energy saving operation.
Select fan mode for basic ventilating fan operation.
Select dry mode for dry operation.
Dry mode Is used to remove humidity from the room without additional cooling.
Once the set temperature is reached, the compressor and circulation fan turns
off. Fan speed is pre-set and cannot be adjusted.
TEMPERATURE CONTROL
The thermostat monitors room temperature to
maintain the desired temperature.
The thermostat can be set between 60°F~86°F
(16°C~30°C).
The unit takes an average of 30 minutes to adjust the
room temperature by 1°F.
^ REMOTE CONTROL SENSOR
mmm
During operation in failure of electric power, the unit runs as previous setting operation.
Owner’s Manual 17