Cadillac 2010 Escalade EXT - Manual (Page 193)

IntelliBeam ® may not turn off the high-beams if the
system cannot detect other vehicle's lamps because of
any of the following:
. The others vehicle's lamp(s) are missing,
damaged, obstructed from view or otherwise
undetected.
. The other vehicle's lamp(s) are covered with dirt,
snow and/or road spray.
. The other vehicle's lamp(s) cannot be detected
due to dense exhaust, smoke, fog, snow, road
spray, mist or other airborne obstructions.
. Your vehicle's windshield is dirty, cracked or
obstructed by something that blocks the view of
the IntelliBeam light sensor.
. Your vehicle's windshield is covered with ice, dirt,
haze or other obstructions.
. Your vehicle is loaded such that the front end of
the vehicle points upward, causing the IntelliBeam
sensor to aim high and not detect headlamps and
taillamps.
. You are driving on winding or hilly roads.
You may need to manually disable or cancel the
high-beam headlamps by turning the low-beam
headlamps on, if any of the above conditions exist.
Disabling and Resetting IntelliBeam
®
at the Rearview Mirror
IntelliBeam ® can be disabled by using the controls on
the inside rearview mirror.
AUTO
3
(On/Off): To disable the system, press this
button on the inside rearview mirror. The IntelliBeam ®
indicator will turn off and will not come back on until the
IntelliBeam
® button is pressed again.
(Stalk Disable) : When IntelliBeam ® has turned on the
high-beams, pull or push the high-beam stalk. This will
disable IntelliBeam
® . The IntelliBeam ® indicator on the
mirror will turn off. To re-enable IntelliBeam ® , press the
IntelliBeam ® button on the mirror.
A different sensitivity setting is available for dealer
diagnostics. This is done by pushing and holding this
button for 20 seconds until the IntelliBeam
® indicator
light flashes three times. If you accidentally activate
this, the vehicle's setting will automatically be reset
each time the ignition is turned off and then on again.
4-13