Cadillac 2010 Escalade EXT - Manual (Page 192)

Turning On and Enabling IntelliBeam
®
Press and release the IntelliBeam ® button on the inside
rear view mirror. The IntelliBeam
®
indicator on the
mirror will turn on to let you know the system has been
turned on. Once the system has been turned on, it will
remain on each time the vehicle is started. Additionally,
the IntelliBeam
® system must be enabled.
To enable the IntelliBeam ® system, turn the exterior
lamp control to AUTO, with the turn signal/multifunction
lever in its neutral position. The High-Beam On Light
will appear on the instrument panel cluster when the
high-beams are on. See Highbeam On Light on
page 4‑38.
Driving with IntelliBeam
®
IntelliBeam ® will only activate your high-beams when
driving over 20 mph (32 km/h).
The high-beam headlamps will remain on, under the
automatic control of IntelliBeam
® , until any of the
following situations occur:
. The system detects an approaching vehicle's
headlamps.
. The system detects a preceding vehicle's
taillamps.
. The outside light is bright enough that high-beam
headlamps are not required.
. The vehicle's speed drops below 15 mph
(24 km/h).
. The headlamp stalk is moved forward to
the high-beam position. See Headlamp
High/Low-Beam Changer on page 4‑5.
When either of these conditions occur, the
IntelliBeam
® feature will be disabled and the
IntelliBeam ® light in the mirror will turn off until the
high-beam stalk is returned to the neutral position.
. If IntelliBeam ® was using low-beams prior to this
action, the IntelliBeam ® feature will be temporarily
disabled until the stalk is returned to the neutral
position.
. The exterior lamp control is turned to any setting
except AUTO.
When this occurs, IntelliBeam ® will be disabled
until the control is turned back to the AUTO
position.
. The IntelliBeam ® system is turned off at the inside
rearview mirror.
4-12