Craftsman 836.27233 - Manual (Page 8)

TO NAIL (FIGURE 2)
AWARNING
Always wear safety goggles or safety
glasses with side shields when
operating your nailer. Failure to do so
could result in objects being thrown
into your eyes, resulting in possible
serious injury.
1. Plug nailer into 120 Volt, 60Hz
power outlet,
2. Hold nailer firmly with the tacking
mouth (1) flat to the workpiece.
3. Use enough downward pressure to
depress the safety lock pin (2).
NOTE: The safety lock pin must be
depressed for this nailer to operate.
This nailer will not fire unless this
is done.
4. Squeeze the trigger (3) to drive the
brad nail.
5. If the workpiece is very hard, press
down on the housing cap (4) with
your free hand.
NOTE: AVOID BLANK SHOTS to
prevent wear and damage to
internal parts.
AWARNING
Do not allow familiarity of your nailer to
make you careless. Remember that a
careless fraction of a second is sufficient
to inflict severe injury.
Fig. 2
MAINTENANCE
AWARNING
The nailer must be disconnected from
the electrical power source during
maintenance.
STANDARD MAINTENANCE
1. Inspect all screws and tighten
if necessary.
2. Use a clean cloth to remove dirt
from the tool.
3. Do not use gasoline, brake fluid, oils,
or solvents to clean plastic parts.
These chemicals will damage,
weaken, or destroy plastics.
4. Do not oil or grease any parts.
5. Keep the nail magazine chamber
dean.
6. Do not rotate or remove housing
cap.
AWARNING
Do not alter, redesign parts on this
nailer, or attach special fixturing. This
can be a source of personal injury.
Page 8