Craftsman 917.275031 - Manual (Page 20)

• Keep battery and terminals clean.
• Keep battery bolts tight.
• Keep small vent holes open.
• Rechargeât 6-10 amperes for 1 hour.
NOTE: The original equipment battery on
your tractor is maintenance free. Do not
attempt to open or remove caps or covers.
Adding or checking level of electrolyte is
not necessary.
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and
terminals can cause the battery to “leak"
power.
1. Remove terminal guard.
Disconnect BLACK battery cable first
then RED battery cable and remove
battery from tractor.
Rinse the battery with plain water and
dry.
Clean terminals and battery cable ends
with wire brush until bright.
5. Coat terminals with grease or petro­
leum jelly.
6. Reinstall battery (See “REPLACING
BATTERY" in the SERVICE AND
ADJUSTMENTS section of this
manual).
V-BELTS
Check V-belts for deterioration and wear
after 100 hours of operation and replace if
necessary. The belts are not adjustable.
Replace belts if they begin to slip from
wear.
TRANSAXLE COOLING
Keep transaxle free from build-up of dirt
and chaff which can restrict cooling.
CHECK TRANSAXLE OIL LEVEL
1. Block up rear axle securely.
Remove left rear wheel by removing
hub bolts.
Remove filler plug from transaxle. Oil
level must be even with plug threads,
necessary, fill with SAE 30 motor oil,
API SF-SJ. Replace filler plug.
Reassemble wheel to hub.
2
.
3.
4.
2
.
3.
4.
'Transaxie Filler
Plug
LUBRICATION
Only use high quality detergent oil rated
with API service classification SF-SJ.
Select the oil's SAE viscosity grade
according to your expected operating
temperature.
If
Change the oil after every 50 hours of
operation or at least once a year if the
tractor Is not used for 50 hours in one
year.
Check the crankcase oil level before
starting the engine and after each eight
(8) hours of operation. Tighten oil fill cap/
dipstick securely each time you check the
oil level.
TO CHANGE ENGINE OIL
Determine temperature range expected
before oil change. All oil must meet API
service classification SF-SJ.
• Be sure tractor is on level surface.
• Oil will drain more freely when warm.
• Catch oil in a suitable container.
1. Remove oil fill cap/dipstick. Be careful
not to allow dirt to enter the engine
when changing oil.
Remove cap from end of drain valve
and install the drain tube onto the fitting.
Unlock drain valve by pushing upward
slightly and turning counterclockwise.
To open, pull down on the drain valve.
After oil has drained completely, dose
and lock the drain valve by pushing
upward and turning clockwise until the
pin is in the locked position as shown.
Remove the drain tube and replace the
cap onto to the end of the drain valve.
Refill engine with oil through oil fill
dipstick tube. Pour slowly. Do not
overfill. For approximate capacity see
“PRODUCT SPECIFICATIONS" section
of this manual.
Use gauge on oil fill cap/dipstick for
checking level, insert dipstick into the
tube and rest the oil fill cap on the tube.
Do not thread the cap onto the tube
when taking reading. Keep oil at
“FULL” line on dipstick. Tighten cap
onto the tube securely when finished.
Oil Drain Valve
2 .
3.
4.
5.
8 .