Craftsman 286.25574 - Manual (Page 21)

TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
An unusually ,
large amount
of sparks 1. Damaged teeth
2. Feed speed is too stow
3. Blunt leeSh
1. Replace Wades
2. Increase feed speed
3. Replace Wades
A lot of wear
in sections 1. Feed speed is too fast
2. Damaged teelh
3. Blunt teeth
4. Not cutting perpendicular
to work surface
1 Reduce feed speed
2. Replace blades
3. Replace blades
4. Hold saw perpendicular
to work surface
Blades are
breaking 1. Damaged teeth
2. Feed speed is too fast
3. Blunt teelh
4. Blades have buckled
5. Blades have burned out
1. Replace blades
2. Reduce feed speed
3. Replace blades
4. Replace blades
5. Replace blades
Possible causes
of broken teeth 1. Feed speed is too fast
2. The surface being
cut is too hard
3. The teeth have been
damaged by impact
4. Blades were not
installed property
5. Blades are burned out
6. Not cutting perpendicular
to work surface
1. Reduce feed speed
2. Replace blades
3. Replace blades
4. Replace blades and follow
the proper blade installation
instructions
5. Replace Wades
6. Replace blades and always
hold saw perpendicular to
work surface when cutting
iSEMa
A w ARNING: This Twin Cutter saw uses specially designed 6 Vs-m. blades
and no other types of blades should ever be used. Other blades will not operate
safely in this saw and could result in serious personal injury.
The following accessories for your Twin Cutter saw are available at your local
Sears store,
9-61131 — A packaged set of 2 Universa! Twin Cutter Saw Blades
9 26678 — 6 PackagedWax Lubricating Sticks
A
WARNING:
The use of attachments or accessories that are not
recommended might be dangerous.
21
5-25-06