Craftsman 286.25574 - Manual (Page 12)

OPERATION cpnt
STARTING A CUT
IMPORTANT:
BEFORE using the Twin Cutler Saw for the first time, ALWAYS familiarize yourself
with the saw by making praotice cuts in scrap materials.
The weight of this saw helps to make the cuts smoother. Learn how to safely handle
and control the weight of the saw.
ALWAYS be sure that you position the blades perpendicular to the piane of the
workpiece. Make the cut at an approximate 30* angle to the workpiece surface,
(See Fig, 5).
Practice the proper feed speed rate for the materials being cut.
Engage the on/off switch to start the saw. ALWAYS let the blades reach full speed
before you begin the cut into the workpiece,
IMPORTANT: When using your saw, ALWAYS stay alert and exercise control.
DO NOT remove your saw from the workpiece, while the blade is moving.
Blades perpendicular to workpiece
Approximately 30®
A WARNING: ALWAYS
maintain proper control of the saw
to make sawing safer and easier.
Loss of control of the saw could
cause an accident resulting in
possible serious Injury.
one hand (see Rg. 6) .
ALWAYS hold saw by motor body and
assist handle (see Fig. 7).
DUTY CYCLE
30 minutes on 10 minutes off duty cycle refers to short-time operation. Short
time operation denotes operation under normal toad for a specified period and
material, starting cold, the interval between each period of operation being sufficient
to allow the tool to cool down approximately to room temperature.
12