Craftsman 315.273731 - Manual (Page 51)

OPERATION
NON-THROUGH CUTS
See Figure 48.
A WARNING: Unplug the saw while removing or
replacing the blade guard. Turn on the saw with
the switch on the arm to confirm the blade is not
receiving power.
■ Remove the blade and blade guard (see Assembly
section).
■ Place a support the same height as the saw table
nearby for the cut work. Lower the blade with the
elevating handwheel.
■ Make sure the wood is not touching the blade.
Insert the key and turn on the saw. Let the blade
build up to full speed before contacting the work­
piece.
A WARNING: Always use push blocks when
making non-through rip cuts to avoid the risk of
serious injury. Never feed wood with your hands.
■ When the work is completed, press the switch off
and remove the key.
NON-THROUGH CUT
C o n t r o l C u t S e t t i n g s
Crosscut
Wood
Type
Setting
Position Feet
Minute
Hard A 0-6
Medium B 0-20
Soft C 0-35
Bi3vel Crosse ut
Wood
Type Setting
Position Feet
Minute
All Types A 0-6
U iter Crosse ut 1
Wood
Type Setting
Position Feet
Minute
Hard A 0-6
Medium B 0-20
Soft C 0-35
Compound Crosscut I
Wood
Type Setting
Position Feet
Minute
All Types A 0-6
51 CRflFTSMFir RADIAL SAW 315.273731