To assemble remaining components, Checklist, Assembly – Craftsman 580.751651 User Manual
Page 8: Fig. 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
Attach wire support to two lower holes in guide handle
with #10 self-drilling screws and #10 flat washers (Fig.
3). The hose minder should be to the left and gun holder
to the right. Be sure loop of support is pointing upward.
Place vinyl cap onto gun holder.
TO ASSEMBLE REMAINING COMPONENTS
IMPORTANT: YOU MUST ASSEMBLE WAND AND AT
TACH
ALL
HOSES
BEFORE
YOU
START
ENGINE.
STARTING
ENGINE
WITHOUT
ALL
HOSES
CON
NECTED
AND
WATER
SUPPLIED
WILL
DAMAGE
PUMP.
Remove cap from top of
pump and insert oil fill
cap
attached
to
other
end
of
yellow
warning
tag.
.
Included with this unit is a Quick-Connect fitting you
attach
to
Water
Inlet
on
pump.
The
quick-connect
includes two parts — a Male Connector factory-in
stalled on water inlet and a Female Connector (Fig. 5).
Remove male connector to inspect Intake Supply
Screen In water inlet for cleanliness and inspect Inlet
Screen on female connector. Reattach male connector
to water inlet and attach female connector to garden
hose,
Unravel
high
pressure
hose,
remove
protective
cap
from end of hose and check other end of hose to see
that threads are properly covered with teflon tape. If
tape is not properly applied, reapply it so threads are
fully covered. The tape seals the connection from hose
to gun and wand assembly.
Attach fitting with tefi on tape to gun and wand assembly
(Fig. 6). You may want to spin gun. Tighten with adjust
able wrench to keep hose from twisting.
Attach the other end of the high pressure hose to htgh(
pressure fitting on pump (Fig. 7). Tighten with adjust-'
able wrench.
(
DETERGENT PICKUP TUBE
iGH PRESSURE
nwoC
FIG. 7
•
Attach Detergent Pickup Tube and Filter as shown in
Fig. 7.
•
To attach the adjustable nozzle, refer to Operation
section, Fig, 9.
CHECKLIST
•
Check that fasteners you used to instali wheels and
handle
are
tight.
Vibration
during
operation
may
loosen fasteners that are not tight enough.
•
Check for proper hose connections (high pressure and
water supply) and for tight connections and that there
are no kinks, cuts, or damage to the high pressure
hose.
•
Provide proper water supply (not to exceed 140®F).
•
Be sure to read “Safety Rules” and “C^eration” Sfci>
tions before using the pressure washer.