Tools required for assembly, To remove pressure washer from carton, How to set up your pressure washer – Craftsman 580.751651 User Manual
Page 7: Assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
Read these instructions and Operator's Manual in its en
tirety before you attempt to assemble or operate your new
high pressure washer. Your high pressure washer has, for
he most part, been assembled at the factory, except those
>a
Its
i eft unassembled. Before you can operate your new
high pressure washer, you must assemble the wheel kit and
properly connect the hi^ pressure hose.
IF YOU HAVE ANY PROBLEMS WITH THE ASSEMBLY
OF
YOUR
PRESSURE
WASHER,
PLEASE
CALL
THE
PRESSURE WASHER HELPLINE AT 1-800-222-3136.
TOOLS REQUIRED FOR ASSEMBLY
Maliet
2 adjustable wrenches OR the following wrenches:
5/16" (8mm) combination wrench
1/2" (13mm) combination wrench
5/8“ (16mm) combination wrench
11/16" (18mm) combination wrench
7/8" (22mm) combination wrench
15/16" (24mm) combination wrench
TO REMOVE PRESSURE WASHER FROM
CARTON
' Remove two boxes marked "PARTS INSIDE” and re
move the parts contained in both boxes.
Remove unit with one hand under pump and one hand
under recoil starter.
Refer to Page 6, "Contents of Hardware Pack” for an
illustrated listing of all the items included with your pressure
washer. Become familiar with each piece before assen>
bling the pressure washer. Check all contents against the
illustrations on Page 6. If any parts are missing or dam
aged,
call
the
Pressure
Washer
Helpline
at
1-800-222
3136.
HOW TO SET UP YOUR PRESSURE WASHER
TO INSTALL THE WHEEL KiT
Installing the wheel kit requires the tools listed, the guide
handle and items included in the parts carton.
» Prop up the engine end of the main unit. This will allow
you to slip each axle pin into the holes provided on the
side of the base (Fig, 1).
With the axle pin inserted inside the base, grip the end
of the axle pin as shown with an adjustable or 15/16"
combination wrench. This will keep the axle from spin
ning as you fasten the axle to the base with a 5/8" lock
washer, a 5/8''-l8 JAM nut, and an M12 fiat washer.
Place wheels on the axles so the valve side of hub is
facing outward.
Retain each wheel to its axle pin by tapping a push nut
onto end of axle with a mallet.
Attach support legs to base as shown in Fig. 2 with M8
X 20mm hex head capscrews and flange lock nuts.
Tighten with 13mm or 1/2-tnch wrench on each fas
tener. Be sure legs are straight when you are finished.