Craftsman 118.22000 - Manual (Page 8)

UNPACKING
1. Place carton on the floor In an area with sufficient space to Inspect your saw.
2. Remove carton and packing materials from around tool.
3. Inspect the saw for loose or damaged parts. If any parts are damaged or missing,
return the saw to your nearest Sears Store to have it replaced.
LOOSE PARTS LIST
The following items are included with your tile wet saw:
A-7-in. Blade
B " r
B-Blade Assembly Handle
r- O
D G
C-Blade Assembly
Handle Screws (2)
D-Blade Assembly Handle
Washers (4)
2 reg. & 2 locking
E-Hexagonal Blade Wrench
F-Laser Light System
G-Motor Shaft Holding
F Wrench
H-Rip Miter Guide
l-Water Pump Foam Filters
H
(2 additional)
J-Phillips Head Screwdriver
AWARNINGtIf any parts are missing, DO NOT operate this saw untii
the missing parts are repiaced. Faiiure to do so couid resuit in serious
personai injury.
ACAUTION: Foiiow aii of the assembiy and instaiiation instructions in
this manuai before connecting the tiie saw to a power source or turning
it on.
4. Lay tool on a level surface (Fig. 4).
5. To release saw table legs, pull out hook from latch and attach to peg on table base
(fig. 5 and fig. 6 ). Grab and pull the single padded table handle on one end of tile
saw and lift to unfold the first set of legs (Fig.7).
6 . Slide peg on leg into notch on table base (Fig. 8 ). Lock legs into place by tightening
butterfly knobs; repeat on other side.
7. Once legs are securely locked in place, note that telescoping legs can be adjusted
to 3 different heights by loosening “screw knobs” and selecting the appropriate
pinhole for desired height. To adjust height, loosen knobs on telescoping legs and
realign screw knobs to desired operating height; tighten knobs to secure in place.
(Fig. 9)
14
UNPACKING cont.
LOOSE PARTS LIST cont.
8 . To stabilize and level the tile saw, adjust the leveling “set screw” located on the
bottom of the left front leg (Fig. 10).
9. Attach blade/cutting assembly handle with screws provided. Put one of each
washer between screw and blade and tighten screws (Fig. 11).
10. The cutting unit is locked into place during shipment.
Loosen the butterfly knob located on one end of the
bridge (Fig. 12) before using tool. When not in use,
keep cutting unit locked in place to prevent its rolling
back and forth along bridge. There is also a second
locking mechanism on the blade/cutting assembly
that can also be used to lock the blade cutting
assembly anywhere along the bridge of the saw
(Fig. 13).
L
Fig. 4
Fig. 5 Fig. 7
Fig. 8 Fig. 9
1__ X _______
b
Fig. 10
15
1
-
19-06