Craftsman 118.22000 - Manual (Page 7)

DESCRIPTION cont.
KNOW YOUR SAW (Fig. 3)
Your tile wet saw has a precision-built electric motor and it should only be connected
to a 120-volt, 60Hz AC ONLY power supply (normal household currant). DO NOT
operate on direct current (DC). The large voltage drop would cause a loss of power
and the motor would overheat. If the saw does not operate when plugged into the
correct 120-volt, 60-Hz AC ONLY outlet, check the power supply.
This Tile Wet Saw has the following features:
1 .6.7 Amp, 3550 RPM (no-load speed) motor. Provides power and torque for fast,
smooth 90 rip cuts and 0 to 45 miter cuts. The bridge adjusts to allow for 0 to
45 bevel cuts.
2. Easy-to-read bevel and miter scales. Bevel scales on each end of the
adjustable pivoting bridge for 0 to 45 angle adjustments in 5 increments.
Rip/Miter Guide allows 90 rip cuts and 0 to 45 miter cuts. Durable plastic has
embossed 0 to 45 angle adjustments in single degree increments. Clear
window in metal part of rip/miter guide shows ruler on fence to allow accurate
measuring of workpiece .
3. Ergonomically designed handle with sort comfort grip for maximum control and
comfortable hand support when cutting.
4. Includes a 7-in. diameter continuous rim diamond blade for fast, efficient
cutting of ceramic, marble, slate or limestone wall or floor tile. Cuts tiles up to 1 -in.
(25.4mm) thick.
5. Blade/Cutting Assembly glides on permanently lubricated 100% ball
bearings
for long tool life and smooth operation.
6
.
Metal upper blade guard, table base, legs, bridge supports and motor
housing for long-lasting dependable strength. Aluminum bridge and fence.
7. Dual Spray Water Feeder System keeps blade evenly wet for maximum blade
performance.
8 . Easy-to-use knobs for quick miter, bevel and compound miter adjustments, no
tools needed.
9. Project ruler on right fence for quick reference; 1 to 9-inches in 1/8-in increments
10. Laser On/Off Switch - To turn on laser system, push switch to “On”
11 . On/Off Starter Switch with safety tab in the middle - Remove tab when
finished with saw to prevent accidental starting.
12. Splash Guard - Keeps water from splashing so work area stays clean.
13. Leg Adjust Knobs - To change height of table quickly and easily. One leg has
set screw to level saw in work place.
14. Sturdy Plastic Water Tray
15. Fold-up Wheels for easy transporting - wheels pop down effortlessly by pulling
the handle on their axle. You can easily move the folded-up saw from place to
place as your tiling needs dictate.
16. Double Handles on retractable pull for easily moving the folded-up saw, with its
wheels down, to the next job site.
12
DESCRIPTION cont.
KNOW YOUR SAW ( Fig. 3) cont.
H
i-
Hook
Set screw to
level saw
Bevel adjust knob
Bevel Gauge
Double Handle for
moving folded saw
Wheel Assembly
\
2
-
2-06