beautypg.com

Operation – Craftsman 358.791031 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Wing

Nut

ADJUSTING THE HANDLE

^WARNING: When adjusting the

handie, be sure it remains above the

safety label and below the mark or ar­

row on the shaft.

1. Loosen wing nut on handle.

2. Rotate the handle on the shaft to an

upright position; retighten wing nut.

OPERATION

KNOW YOUR TRIMMER
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT Compare the illustrations with your unit to familiarize yourself with the location of

the various controls and adjustments. Save this manual for future reference.

Muffler

Start
Lever

Starter

Handle

ON/STOP SWITCH

The

ON/STOP

switch is located on the

trigger handle and is used to stop the

engine. To stop the engine, push and
release the engine

ON/STOP

switch.

PRIMER BULB

The

PRIMER BULB

removes air from

the carburetor and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the

starter rope. Activate the primer bulb

by pressing it and allowing it to return

to its original form.

START LEVER

The

START LEVER

helps to supply fuel

to the engine to aid in starting. Acti­
vate the starting system by moving the

start lever to the

START

position.

DO

NOT

squeeze the throttle trigger until

the engine has started and runs. After
the engine starts, allow the engine to
warm-up 10-15 seconds, then fully

squeeze the throttle trigger to deacti­

vate the starting system (start lever

returns to

RUN

position).

COUPLER

The

COUPLER

enables optional

at­

tachments to be installed on the unit.

11